Edge pinker
60 Service Instructions 171/173 - 00.0 - 01/2020
12.4 Adjusting point in time for cutting
Proper setting
The edge pinker cuts when the material is not being fed.
This setting applies when the handwheel is set to position A and the needle
plunges into the throat plate.
Fig. 49: Adjusting point in time for cutting (1)
To adjust the point in time for cutting:
1. Loosen the screws (2).
2. Disassemble the control panel (1).
3. Loosen the screw (3).
4. Disassemble the arm cover (4).
(1) - Control panel
(2) - Screws
(3) - Screw
(4) - Arm cover
To Next Page
Loading...
