Programming
70 Service Instructions 171/173 - 00.0 - 01/2020
13.3 Adjusting subclass 550-121 for machines with an edge
pinker
You will only have to adjust this subclass if you replaced the control.
To set the subclass for machines with an edge pinker:
1. Plug the dongle with the machine class into the control.
2. Press the and buttons at the same time.
You are on the Technician level.
3. Select parameter t5104.
4. Press the button.
5. Use the buttons A+/A- to select class 171.
6. Press the button.
7. Use the buttons A+/A- to select subclass 550-121.
8. Press the button.
The data is uploaded to the machine.
To Next Page
Loading...
