Edge pinker
Service Instructions 171/173 - 00.0 - 01/2020 63
12.6 Adjusting the chain cutter
Proper setting
When the chain cutter is extended, the point of the knife - exerting minimum
pressure - lies flat and straight in the slot of the throat plate.
Fig. 52: Adjusting the chain cutter
To adjust the chain cutter:
1. Loosen the screws (1).
2. Adjust the height of the chain cutter.
3. Press the and buttons at the same time.
You are on the Technician level.
4. Select parameter t5112.
5. Use the buttons A+/A- to select the 3
rd
output display.
6. Press the button.
7. Select the value X1.37.
8. Use the buttons D+/D- to retract and extend the chain cutter.
The chain cutter is set correctly when the knife (2) - exerting minimum
pressure - lies flat and straight in the slot of the throat plate.
9. Check the position and pressure of the knife (2) and adjust if necessary.
10. Tighten the screws (1).
(1) - Screws (2) - Knife
To Next Page
Loading...
