Index Page:
3. Transport carriage
3.1 Rearendposition.............................................. 51
3.1.1 Positionofthelimitswitchintheslottedhole ............................. 53
3.1.2 Distancebetweenswitchingscrewandlimitswitch.......................... 53
3.1.3 Stopguidefortransportcarriage..................................... 53
3.2 Changing the toothed belt ........................................ 54
3.3 Adjustingthebelttension......................................... 55
4. Feeding clamps
4.1 Measuring line for aligning the feeding clamps and the folder ................... 56
4.2 Aligning the feeding clamps as to the auxiliary line .......................... 57
4.3 Feeding clamp stroke ........................................... 58
4.4 Distance between the feeding clamps and the folder sole ...................... 59
4.5 Front end position of the feeding clamp................................. 60
5. Knives for corner incision
5.1 Presetting .................................................. 61
5.2 Aligningthecornerknifestationastotheseams........................... 62
5.3 Adjustingtheslantofthecornerincisions............................... 64
5.4 Exchanging the corner knives ...................................... 65
6. Laser markings ............................................... 66
6.1 Aligningthemarkings ........................................... 67
7. Reflected light barriers for flap scanning
7.1 Swivelarm.................................................. 68
7.2 Aligningthelightbarriers......................................... 69
8. Aligning the folding station plate as to the measuring line ................... 70
9. Positioning the sew ing machine head as to the table top .................... 71
10. Folder
10.1 Proper fastening............................................... 72
10.2 Aligning the folder as to the middle of the pocket opening ...................... 73
10.3 Liftingmotionofthefolder......................................... 74
10.4 Position of the folder to the needles ................................... 76
10.5 Guideplatesatthefolder......................................... 77
11. Stacker
11.1 Positionofthepincerstothetabletop ................................. 78
11.2 Heightofthepincer............................................. 78
11.3 Positionandclosingofthepincers.................................... 79
11.4 Cylinder speed ............................................... 80
11.5 Positionoftherestplate.......................................... 80
11.6 Swivellingthestackeraside........................................ 81
12. Exchange the control unit ........................................ 81
To Next Page
Loading...
Need help?
General
