Laser marking lamps
Up to four laser marking lamps can be triggered
in order to facilitate the aligning of the material
(The optional equipment has to be activated)
Needle reverse tur n mode
The following modes can be set:
Not active
The needle remains in the stopping position.
After the complete contour
After the completion of all the seams of a contour
the needle is tur ned back to the set value
(MP parameter).
After each seam (def.)
After each seam the needle will be tur ned back.
Needle cooler
(on/off)
Activated/deactivates the needle cooler.
Adjust the sewing speed
(min. = 10… max. = 200; def. = 100%)
The sewing speed will be adjusted accordingly.
PP2 - Load mode
Feeding mode
The following modes can be set:
Mode 1 (def.)
The clamp will be opened in the feeding position.
After actuating the pedal the clamp will be closed.
After actuating the pedal one more time the seam will
be started.
Mode 2
The clamp will be opened in the feeding position.
After actuating the pedal the left part of the
two-piece clamp for an angular feed will be closed.
After actuating the pedal one more time the right side
will be closed.
After a further actuation of the pedal
the seam will be started.
Mode 3
The clamp will be opened in the feeding position.
After actuating the pedal the right part of the
two-piece clamp for an angular feed will be closed.
After actuating the pedal one more time the left side
will be closed.
After a further actuation of the pedal
the seam will be started.
Mode 4
Quick start mode
The clamp will be opened in the feeding position.
After actuating the pedal the clamp will be closed.
and the seam will be started. With the
change-over clamp, the seam will be started
automatically after feeding.
This mode is only active if the quick start
has been enabled with the machine parameters.
In order to activate the quick start mode, the machine
must be switched off and on again!
30
To Next Page
Loading...
