Thread tension value
Lift st roke ( min. = 1 mm, max. = 10 mm)
Thread trimming
Delete
Via this menu item the line/circular arc entered last can
be deleted.
Memo…
Via this menu item the newly created seam contour
is memorized.
ñòñò Clamp movement
By pressing on of the arrow keys a clamp movement
into the corresponding direction is effectuated.
X=0.0 Y=0.0 Position request
By pressing on the area of the current clamp position
an edit window will pop up in which the new position
can be entered. After confirming the position by
pressing “OK” the clamp will go to the requested position.
Pedal actuation
Depending on the preselected direction of the
movement the clamp goes step by step to the right/left
or downwards/upwards.
52
To Next Page
Loading...
