Accessing the EN-204 via a Web Browser
53
5.4.3.8.1 Configuring Tamper-Proof Area Settings
To create a tamper-proof zone
In the Area Settings screen, click the Draw Area icon.
Drag the mouse over a zone in the live video image.
Click again to stop drawing.
Click the Trash icon to clear all motion detection areas.
Use the Sensitivity slider to vary the sensitivity of the drawing.
The sensitivity setting is applied to every zone.
Repeat steps 2-6 for each zone and for each camera.
Click Save.
5.4.3.8.2 Setting the Tamper-Proof Arming Schedule
Select Camera Settings > Tamper-proof > Arming Schedule to set the schedule for setting a tamper-
proof alarm schedule. The Arming Schedule screen opens.
Figure 53: Tamper-Proof Arming Schedule Screen
To Next Page