Document Information
vii
Document Information
Document Scope and Purpose
The purpose of this document is to provide instructions and installation procedures for:
Physically connecting the EN-204 encoder
Configuring setup parameters via the unit’s web interface
Operating the unit
Note:
This document is intended for use by technical users who have a basic understanding
of CCTV camera/video equipment and LAN/WAN network connections.
Installation must follow safety, standards, and electrical codes as well as the laws that
apply where the units are being installed.
Proprietary Rights and Non-Disclosure
This manual is delivered subject to the following restrictions and conditions:
This document contains proprietary information belonging to DVTEL, Inc. This
information is supplied solely for the purpose of assisting explicitly the licensee of the
DVTEL units.
No part of this document contents may be used for any other purpose, disclosed to any
third party or reproduced by any means, electronic or mechanical, without the express
prior written permission of DVTEL, Inc.
Trademarks and Copyrights
This manual and its contents herein are owned by DVTEL, Inc. All rights reserved.
DVTEL, the DVTEL logo, and Latitude are trademarks of DVTEL, Inc.
Products and trademarks mentioned herein are for identification purposes only and may be
registered trademarks of their respective companies.
DVTEL, Inc. makes no representations whatsoever about any other products or trademarks
mentioned in the manual.
© DVTEL, Inc. 2014. All rights reserved.
To Next Page