DVTEL EN-204 - Network Settings

Accessing the EN-204 via a Web Browser
59
In the Event-Triggered section, enter the following information:
From the Resolution drop-down list, select one of the following resolutions:
 For PAL systems: 704*576, 352*288 (default), or 176*144
 For NTSC systems: 704*480, 352*240 (default), or 176*120
From the Quality drop-down list, select one of the following levels:
 Low
 Medium (default)
 High
From the Interval drop-down list, select the number of seconds (1-5) between
snapshots. The default is 5 seconds.
Note:
To upload captured pictures to an FTP server, enable an event-triggered
snapshot.
Do one of the following:
 Repeat the above steps for each camera.
 To copy these settings to all cameras, check Select All.
 To copy to a specific camera, check the camera.
Click Save.
5.4.4 Network Settings
Network settings (such as device parameters, network connectivity settings, and communication
protocols) must be properly configured before you can operate the encoder over your network.
From the Configuration sidebar menu, select Network Settings. The following tabs should be
configured:
 TCP/IP (page 60)
 DDNS (page 61)
 Email (page 63)
 SNMP (page 64)
 Port (page 67)
 FTP (page 67)
 NetHDD (page 69)
 PPPoE (page 70)
 QoS (page 71)
 SOCKS (page 71)
 UPnP™ (page 72)
 HTTPS (page 73)
 Bonjour (page 77)
 Advanced (page 77)