EasyManua.ls Logo

Dynapac DR6X - Page 106

Dynapac DR6X
114 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Operate the recoil starter 10 to 20 times.
5. Set the engine stop switch to position "ON".
6.
CAUTION!
Danger of injury caused by uncontrolled
machine movement!
Always hold on to a running machine.
Always keep an eye on a running
machine.
Operate the recoil starter once again.
7. If the engine does not start after 3 to 5 attempts, close the
choke and operate the recoil starter once again.
8. If the engine still does not start after 3 to 5 attempts, clean
the spark plug.
Fig. 123
Fig. 124
Fig. 125
Troubleshooting – What to do if the engine has flooded
DR6X
106

Table of Contents