Dynatronics dynatron solaris 705 plus - Saving Custom Default Parameters or Treatment Setups; Adverse Reactions

DYNATRON® THERMOSTIM™ PROBE
DYNATRON SOLARIS
®
PLUS SERIES | SERVICE MANUAL REV. 6 | AUGUST 29, 2017 101
8. Saving Custom Default Parameters or Treatment Setups
Aer completing the treatment setup or aer choosing new default parameters – but before pressing START to begin
a treatment, PRESS and HOLD the START key until a tone sounds. e tone indicates that new Default settings have
been saved, or that the ermoStim treatment parameters are saved for future use.
Dynatron ermoStim Specications
Power Requirements ...............................................................................................................None
Power Consumption ................................................................................................................None
Fuse ............................................................................................................................................None
Dimensions ......................................................................................... 2” (W) x 3.6” (D) x 10” (L)
5.08 cm (W) x 9.14 cm (D) x 25.4cm (L)
Weight ...................................................................26.455 ounces or .1.653 pounds (750 grams)
CAUTION
THERE ARE NO SERVICEABLE PARTS INSIDE THE DYNATRON THERMOSTIM PROBE.
WARNING
WHEN TREATING WITH THE THERMOSTIM PROBE, FOLLOW ALL CONTRAINDICATIONS, WARNINGS,
AND PRECAUTIONS ASSOCIATED WITH THE ELECTRICAL STIMULATION TREATMENT USED IN
COMBINATION WITH HEAT OR COLD.