Dynatronics dynatron solaris 705 plus - Dynatron Tri-Wave Operating Instructions

DYNATRON TRI-WAVE™ OPERATING INSTRUCTIONS
DYNATRON SOLARIS
®
PLUS SERIES | SERVICE MANUAL REV. 6 | AUGUST 29, 2017 63
Dynatron Tri-Wave
™
Operating Instructions
Tri-Wave Light erapy provides delivery of a single wavelength of light or any combination of 3-wavelengths of light (red,
infrared, and blue) that allow for 7 dierent light treatment combinations. e Tri-Wave Light Probe or 2 robust 5” x 7”
Tri-Wave Light Pads deliver the desired treatment. Dual Light Pads allow for greater coverage of a joint, treatment of 2
separate areas at the same time, and the ability to treat large areas of the body when placed side-by-side. e Solaris Plus 707
has the unique ability to utilize two Light Probes and two Light Pads simultaneously.
e Solaris Plus Tri-Wave Light erapy probe is specically designed for treating smaller areas. e probe has a treatment
area of 6 cm
2
and should be applied in direct contact with the surface of the skin over the treatment area. To treat areas
larger than 6 cm
2
individual treatments should be given one at a time in a grid pattern until the desired treatment area is
covered unless treating large areas where the Dynatron Tri-Wave Light Pads (5” X 7” each) would be more suitable. Please
see published literature for specic treatment parameters.
e Dynatron Tri-Wave probe and the Dynatron Tri-Wave Pads have been cleared by the FDA to provide topical heating for
temporary increase in blood circulation, temporary relief of minor muscle and joint aches, pain and stiness and relaxation
of muscles; for muscle spasms and minor pain and stiness associated with arthritis.
WARNING
Protective eyewear is required for patient and practitioner.
CAUTION
e Dynatron Tri-Wave probe and the Dynatron Tri-Wave Pads must be plugged securely into the respective output
jacks prior to turning ON the Solaris Plus base console.