Dynatronics dynatron solaris 705 plus - Direct Current Warnings

DIRECT CURRENT MODALITY INFORMATION
DYNATRON SOLARIS
®
PLUS SERIES | SERVICE MANUAL REV. 6 | AUGUST 29, 2017 62
Direct Current Warnings
It is important that excellent coupling be maintained any time current is owing. Increased resistance from poor coupling or
excessive current density can cause skin reactions.
• Electrodes must be attached and probe placed in contact with the patient’s skin prior to starting the treatment.
• Direct Current tends to lower surface sensory perception as the treatment proceeds. e patient must have good
sensory perception if Direct Current is to be used.
Direct Current Default Setting
Pulse Duration: ................................................................................... 100 mSec
Polarity: ..................................................................................................Negative
Intensity: .............................................................................................................1
e following default settings are set by the manufacturer:
Waveform: .................................................................................................Square
Pulse Duration: .............................................................................. .1-500 mSec
Pulse Duration Selections: .................................. 0.1, 0.3, 0.5, 1, 10, 100, 500
Power Output: ........................................................................................ 20 mA.
Note: Load impedance does not aect output of the DC waveform.