DIRECT CURRENT INSTRUCTIONS
DYNATRON SOLARIS
®
PLUS SERIES | SERVICE MANUAL REV. 6 | AUGUST 29, 2017 60
7. STOP
When the desired muscle contraction has been reached, press the ON/OFF key on the MultiStim Probe handle to
end the treatment. When the ON/OFF key on the probe handle is pressed, two quick beeps will be heard indicating
that the DC treatment is complete.
If the DC treatment is in focus, pressing and holding the FUNCTION and pressing the STOP key will also STOP the
treatment.
NOTE: Treatment setup may be saved as new Default settings by pressing and holding down the START key until a
beep sounds. However, the intensity setting is not saved but must be reset with each individual patient.
To Next Page
Loading...
