Dynon SkyView SE - Page 103

Messages and Alerts
SkyView SE Pilot’s User Guide - Revision I 9-17
Message
Message Explanation
Recommendation
DPSK UNLOCK
Internal diagnostic warning.
Internal fault, contact Dynon
Technical Support for help.
REMOTE HOT (value)
Transponder is receiving
excessive heat; value is
Temperature (°C).
Check location of
transponder for exposure to
excessive heat.
RX PSU FAIL
Internal diagnostic warning.
Internal fault, contact Dynon
Technical Support for help.
SQUITTER FAIL
Extended Squitter data not
transmitted.
Internal fault, contact Dynon
Technical Support for help.
TX POWER LOW (value)
Transmit power output is
low; value is Power output.
Generally, an installation
issue with antenna, feedline,
or connector. Check
antenna, feedline, or
connector. A visual
inspection is often not
sufficient to find the fault.
TX PSU HIGH (value)
Transmitter power supply
output is abnormally high;
value is Volts.
Internal fault, contact Dynon
Technical Support for help.
TX PSU LOW (value)
Transmitter power supply
output is abnormally low;
value is Volts.
Check power being supplied
to SV-XPNDR-26X.
TX RESTART
Internal diagnostic warning
Remove and re-apply power
to transponder.
TXPNDR FAULT
Generic fault message
Internal fault, contact Dynon
Technical Support for help.
Table 9 – SV-XPNDR-261/262 Error Messages
AOA Alerts
When AOA audio alerting is enabled, it enables a progressive tone that increases in intensity as
AOA increases. It is similar in nature to a conventional reed-type aircraft stall warning sound,
although it is much more predictable in its progression. It can be set to start its progressive
tones at either the border of the yellow/green marks on the AOA bars, the middle of the
yellow, or at the yellow/red border. The tones start at the level selected and get progressively
quicker and closer together until a solid tone is played at critical AOA (in the red).