Dynon SkyView SE - Specific Alerts and Audio Details

Messages and Alerts
SkyView SE Pilot’s User Guide - Revision I 9-5
from backup battery (if installed). In this condition, the pilot must choose whether to keep the
display on (on battery power) or to power the display off.
Audio Alerts
When connected to an audio panel or intercom, SkyView SE can generate tones or voice alerts
for various conditions.
Inhibited Alerts
Audio alerts that occur within 5 seconds of SkyView SE initially powering on are inhibited to
reduce transient nuisance alerts that may occur as SkyView SE comes online.
Engine Alerts can be optionally configured to be inhibited before engine start or 5 minutes,
whichever comes first. See the SkyView Classic / SE / HDX System Installation Guide for details.
Messages, Alerts, and Audio Alert Details
Spoken Alert
(if configured)
Message Displayed in
Message Window
Visual Alert
(severity)
Description
"Warning"
ADAHRS CAL CORRUPT
The calibration of the ADAHRS
module is corrupt. Contact Dynon
Avionics for assistance
"ADAHRS Cross
Check Error"
ADAHRS CROSS CHK
ERROR
Displayed after an ADAHRS cross-
check error was announced in a
multi-ADAHRS systems and one of
the ADAHRS modules was not
disabled.
"Warning"
ADAHRS FAIL
SkyView has detected a problem
with the ADAHRS module.
"Warning"
ADAHRS INTERNAL
ERROR
SkyView has detected a problem
with the ADAHRS module. Contact
Dynon Avionics for assistance.
"Electrical Current"
AMPS HIGH
Electrical current indicator has
entered configured red high
range.
"Electrical Current"
AMPS LOW
Electrical current indicator has
entered configured red low range.
"Warning"
ARINC-429 OFFLINE
The ARINC-429 module is not
communicating SkyView.
"Warning"
AUDIO OUTPUT FAIL
SkyView has detected a problem
with the audio system.