Eads Two-Way Radio User Manual

Positioning
69
To remove waypoint information from the idle mode display, select
Position settings → Waypoint idle off.
To deactivate position information in idle mode, select
Position
settings
→ Display position info in idle mode → Off.
Position settings
To change settings related to positioning, select Menu →
Positioning → Position settings. You need access rights to modify the
position settings. For more information, contact your organisation.
GPS receiver
Select GPS receiver → GPS automatic to activate the GPS receiver
only when you open
Positioning from the menu, send information
using NMEA interface, or receive a position request that is
answered. Select
GPS always on to have the GPS receiver active all
the time. Using the GPS receiver may drain the battery faster.
Allow position info sending
The radio may receive requests for position information or for
network information. In network-based positioning the approximate
position of the radio can be calculated according to the location of
base stations without using the GPS satellites. Position information
sending is only possible in the network mode and when transmission
barring is not activated.
Note that this feature and its accuracy are dependent on the
network, satellite systems (when GPS is used), and the organisation
receiving the information. This feature may not function in all areas
or at all times.
To set how the radio responds to position requests or sends position
information automatically, select
Allow position info sending, and
one of the following:
• Yes — The radio attempts to send position information when a
predefined value is reached, such as a time period or distance, or
whenever position requests are received from numbers

Eads Two-Way Radio Specifications

General

Brand	Eads
Model	Two-Way Radio
Category	Two-Way Radio
Language	English