Table of Contents
Introduction
How to Use This Owner's Manual
Notes Used in This Manual
Safety
Laser Safety
Electrical Safety
Installation
Get to Know the Components of the Laser System
Get Prepared for the Installation
Unpacking the Laser System
Set up the Machine
(For 3kW Only) Set up the Control Console
(For 6kW Only) Set up the Control Console
(For 6kW Only) Install the Fiber Laser
Connecting the Chiller
Connecting the Exhaust(s)
Connecting the Voltage Regulator
Connecting the Transformer
Connecting the Assist Gas
Getting Started
Turn on the Laser System
Turn off the Laser System
Handheld Remote
CypCut Basics
Parts in CypCut
Operation
Hints for Programming Parts
Import Parts
Construct Parts
Part Library
Nest Parts
Technology in CypCut
Hints for Setting Technology
Cutting Parameters
To Next Page
Loading...
