Handheld Remote
The EV-30 laser system comes with a handheld remote in your convenience, which integrates most common
functions on it, such as jogging, tracing, starting and pausing a job, etc.
With the remote, you can keep your eyes on the machine when moving the laser head, or controlling the
machining process, avoid making mistakes or operation delays when switching back and forth between the
software and the machine.
Button Label Function
Start To start or resume a job.
Pause To pause a job.
Dry Cut
To simulate a job, without firing laser, blowing gas, and the laser head will
not move down following along the sheet unless being enabled in CypCut.
Stop To stop a job.
Frame
To preview the placement of the parts on the sheet before running the job.
The laser head will trace the entire outline of the job.
To Next Page
Loading...
