Installation
Follow the steps below to set up your EV-30 laser system, and to be ready to get started.
1. Get to know the components of the laser system.
2. Get prepared for the installation.
3. Unpack the laser system.
4. Set up the machine.
5. (For 3kW only) Set up the control console.
6. (For 6kW only) Set up the control console.
7. (For 6kW only) Install the fiber laser.
8. Connect the chiller.
9. Connect the exhaust(s).
10. Connect the voltage regulator.
11. Connect the transformer.
12. Connect the assist gas.
To Next Page
Loading...
