Turn off the Laser System
Follow the steps below to turn off the EV-30 laser system, refer to Turn on the Laser System for more
operating details.
1. Close the CypCut software.
2. Turn off the computer.
3. (For 3kW only) Turn off the fiber laser.
4. Turn off the machine.
5. Turn off the main switch.
6. Switch off the assist gas.
7. (For 6kW only) Turn off the fiber laser.
8. Turn off the chiller.
9. Turn off the voltage regulator.
The exhaust(s) will be turned off automatically at the same time.
10. Switch off the electrical power.
To Next Page
Loading...
