Introduction
Page 6
706rEUR-00 10mW tilt switch and personal attack transmitter.
710rEUR-00 Dual-button personal attack transmitter
713rEUR-00 Pet-tolerant PIR
714rEUR-00 PIR
XCELR PIR
XCELRPT Pet-tolerant PIR
DET-RDT Combined microwave and PIR detector range
720rEUR-00 Smoke detector
DET-RSMOKE Smoke Detector
726rEUR-50 Long-range hand-held personal attack transmitter
726rEUR-60 Short-range hand-held personal attack transmitter
734rEUR-00 CC door contact - white
734rEUR-01 FSL door contact - white
734rEUR-05 CC door contact - brown
734rEUR-06 FSL door contact - brown
738rEUR-00 Spyder shock sensor – white
738rEUR-04 Spyder shock sensor – brown
DET-RDCS Spyder shock sensor and door contact combined
739rEUR-00 Glass-break interface
739rEUR-50 Glass-break with tamper
DET-RWATER Flood detector
DET-RARB Request-for-assistance button
703R Universal transmitter
701rEUR-50 Long-range neck pendant transmitter
701rEUR-60 Short-range pocket transmitter
702rEUR-00 Watch/Pendant transmitter
Wired detectors
Standard wired detectors can connect (using standard alarm cable) to the control unit.
Please refer to page 9 for details of the different wiring methods you can use for wired
detectors. If 4-wire CC wiring is used, this halves the available number of zones; see page
10.
Note: Ideally, all detectors should be power-free (e.g. door contacts). Powered detectors
(e.g. PIRs) need to be powered by an alternative backed-up power source (see Power
availability on page 8).
Sounders
The control unit supports external and internal sounders, as described next.
Table 1 specifies the number of sounders supported.
To Next Page
Loading...
