Eaton i-on Style - Chapter 5: Installer Menu Map

Page 17
Chapter 5: Installer Menu Map
Important: The defaults listed below enable the control unit to comply with EN50131
requirements. If you change those settings, the installation may no longer comply. If the
control unit does not comply with EN50131, you must remove any labelling that indicates
compliance.
Some options are not always visible as the relevant hardware is not fitted, or not
applicable to the control unit type.
MENU Option
Factory Default
Notes
1 Detectors/Devices
Detectors
Add/Del Detectors
Zone nnn...
Delete all
Program Zones
Zone 000...
Name
“Zone nnn”
Type
Not used
Partitions
None
Visible only in a partitioned system and
when zones have a type other than
“Not Used”.
Attributes
All "off", except Supervision
Visible when zone is given a type other
than “Not Used”.
Some attributes are only available on
particular zone types.
Double Knock does not comply with
EN51031.
Masking must be enabled in System
Options.
On-board
Keypad
Home Key Action
Set
Hot Key Action
Not Used
Audible Keys
Enabled
Radio
Keypads
i-rk01
Add/Del Radio Kpd
Edit Keypads
Radio Kpd 01...
Name
“Radio Kpd 0n”
Partitions
Partition 1
Visible only in a partitioned system.
Key A
Name: “Key A”
Setting: Partition 1 Full Set
OR Full Set in a Part Setting
System
Key B
Name: “Key B”
Setting: Partition 2 Full Set
OR Part Set B in a Part Setting
System
Key C
Name: “Key C”
Setting: Partition 3 Full Set
OR Part Set C in a Part Setting
System
Key D
Name: “Key D”
Setting: Partition 4 Full Set
OR Part Set D in a Part Setting
System
External
Sirens
Add/Del Siren
Edit Siren
Radio SRN 01...
Name
“Radio SRN 0n”
Partitions
Partition 01
Visible only in a partitioned system.