Settings Options and Partitions Menus
Page 55
Part Set Exit Mode
Pt.set Settle Time
Part Set Exit Time
Pt.set Entry Time
Pt.set Alarm Resp.
Pt.set Siren Delay
Pt.set Siren Time
These options control system behaviour when the system is part set. Please refer to the
equivalent full-set options described above.
Pt.set Final Exit
This option controls how the system uses Final Exit zones when the system is part set.
Final Exit
In a part-setting system, any zones of type Final Exit with Part Set B, C or D
attributes continue to act as Final Exit zones during part setting.
In a partitioned system, any zones of type Final Exit that belong to the partition and
have the Part Set attribute continue to act as Final Exit zones during part setting.
Normal Alarm
In a part-setting system, any zones of type Final Exit with the Part Set B, C or D
attributes act as Normal Alarm zones during part setting.
In a partitioned system, any zones of type Final Exit that belong to the partition and
have the Part Set attribute act as Normal Alarm zones during part setting.
Pt.set Entry Route
This option controls how the system treats Entry Route zones when the system is part set..
Entry Route
In a part-setting system, any zones of type Entry Route with the Part Set B, C or D
attributes continue to act as Entry Routes zones during part setting.
In a partitioned system, any zones of type Entry Route that belong to the partition
and have the Part Set attribute continue to act as Entry Routes during part setting.
Final Exit
In a part-setting system, any zones of type Entry Route zones with the Part Set B, C
or D attributes act as Final Exit zones during part setting.
In a partitioned system, any zones of type Entry Route that belong to the partition
and have the Part Set attribute act as Final Exit zones during part setting.
Pt.set Strb Set
Pt.set Strb Unset
These options control strobe behaviour when the system is part set. Please refer to Strobe
on Set and Strobe on Unset above.
To Next Page
Loading...
