Eaton i-on Style - IP Network (Own)

Communications Menu
Page 86
JV
JX
RH
User a changed user b’s code
User a deleted user b
User codes defaulted
User Code
Change
LB (RB)
Installer mode start keypad (web)
Installer Mode
LR, LT
Comms line fault and restore
Faults
LS (RS)
Installer mode end keypad (web)
Installer Mode
OR
System or partition reset
Reset
PA, PR
Zone HUA (PA) and restore
Control unit HUA (PA) and restore
RF HUA (PA), RF HUA (PA) restore
Radio keypad HUA (PA), radio keypad HUA (PA)
restore
Hold Up Alarm
PT, PJ
Zone HUD fault and restore
Faults
RS
Downloading successful
Downloading
RU
Downloading failed
TA, TR
Detector tamper and restore
Lid tamper and restore
Bell tamper and restore
Radio keypad tamper and restore
External siren tamper and restore
Internal sounder tamper and restore
WAM tamper and restore
Tampers
TA, TR
WAM trouble and restore
Faults
UA, UR
Technical alarm and restore
Technical Alarm
UA, UR
Perimeter and Perimeter restore
Burglar Alarm
UB, UU
Zone bypass and un-bypass (shunt)
Omit
XQ,HQ
Jamming fail and restore*
RF Jamming
XT, XR
Zone low battery fail and restore
RF Battery/PSU
YA, YH
Zone External Warning Device fault and restore
Fault
YM, YR
Control unit battery low/ missing and restore
Panel Battery
YM, YR
External battery fault and restore
Faults
YP, YQ
Smoke/WAM psu fail and restore
RF Battery/PSU
YP, YQ,
DC fail and restore
Faults
YT, YR
Ext Siren/WAM low battery fail and restore
RF Battery/PSU
YT, YR
Control unit battery low/fail and restore
Panel Battery
YT, YR
External PSU low volts via zone n
Faults
YW
System error
Faults
*Note: The control unit communicates Jamming and Supervision when the system is
unset.
Restorals
When you enable a CID/SIA Report Group, or when you use Fast Format reporting, the
control unit communicates both when an event occurs, and when the condition causing the
event stops. The second communication is also called a “restore”.