Eaton i-on Style - Chapter 6: Detectors;Devices Menu; Detectors (zones)

Page 25
Chapter 6: Detectors/Devices Menu
This chapter explains the options in the Detector/Device menu.
Detectors
Add/Del Detectors
This option allows you to add and delete radio detectors (zones).
Adding radio detectors
To add a radio detector:
1. Select a zone.
A to the right of a zone name indicates that the control unit has learned a radio
detector for that zone.
2. When prompted, activate the detector's tamper switch to make the control unit learn
the identity of the radio detector.
Deleting radio detectors
To delete a single radio detector, select the zone and choose one of the following:
Delete Detector ID
This deletes the ID of the detector, but leaves any zone configuration in place (such
as zone type and attributes).
Default zone
This deletes the ID of the detector and sets all the zone configuration to default
values.
Note: The deletion takes place immediately, and not when you leave the Installer menu.
When you delete a radio detector, the control unit sets the zone to Not Used, and deletes
the identity of the radio detector that it has learned.
The Delete all option (see the menu map on page 17) allows you to delete all radio zones.
Program Zones
You can program (configure) each zone's behaviour at any time, whether or not a wired
detector is connected, or the control unit has learned the identity of a radio detector. Select
the zone you wish to program. Zones 000 to 039 are radio zones; 040 to 043 are the wired
zones.
Note:
 If a wired zone does not have a detector connected to it, make sure that its zone
type is Not Used (the default).
 If you program a radio zone but the control unit does not have a detector learned for
that zone, the display shows “Zone programmed but not learnt” when you leave the
Installer menu.