System Options Menu
Page 71
RKP Entry PrtSt
This option relates to the use of one-way radio keypads when unsetting a part-set system
or part-set partition.
Enabled
The user must first trigger a Final Exit zone and start the entry timer before unsetting
a part-set system or partition with a radio keypad. The system unsets those partitions
the user is assigned to that have an active entry timer. If a partition that the user is
assigned to does not have an active entry timer, the partition remains part set.
Disabled
The user can unset a part-set system or partition using a radio keypad without first
starting the entry timer. The system unsets all partitions that the user is assigned to.
HUA Response
This option is available only for part-setting systems. In a partitioned system, each partition
can have its own HUA response. See page 51 for a description of this option.
PZ Unset Response
This option is available only for part-setting systems. See page 52 for a description of this
option.
PZ Unset Response
This option is available only for part-setting systems. See page 52 for a description of this
option.
PZ Reset time
This option is available only for part-setting systems. See page 53 for a description of this
option.
Auto Rearm
This option is available when System Options – Confirmation Mode is set to Basic (page
62).
Use this option to specify the number of times that the system will re-arm when the siren
time expires.
Select NEVER to make the system never re-arm (the system will go into alarm once only).
Select one of the other options to make the system re-arm once, twice, three, four or five
times, or always. The system re-arms all closed zones, but not detectors that are still
sending alarm signals. (Note that this setting is required in order to comply with EN50131.)
If the system has rearmed, then when a user enters the system through the Final Exit
door, the control unit will give an audible internal alarm in place of the normal entry tone.
On-Board Sounder
Volume
Use this option to change the volume of sound (e.g. alarm, set and unset tones) from the
internal sounder located inside the control unit.
To Next Page
Loading...
