Eaton i-on Style - Call Mode; Messages; Triggers

Communications Menu
Page 89
Table 11: Speech Dialler Commands
Function
Key
Listen – silence any internal sounders and activate the
on-board microphone to hear any noise within the
range of the microphone. The control unit automatically
switches to listen mode after the message has been
played six times
1
Speak – silence any internal sounders and activate the
on-board loudspeaker to speak to anyone at the
premises. Note: Speak and Listen modes cannot
operate at the same time.
2
Switch between Speak and Listen modes
*
Play the message again
3
End this call and let the control unit contact the next
nominated person for this alarm.
5
Clear down and do not call any of the other nominated
persons for this alarm.
9
Note that when the called party answers a speech dialler call, there could be a six-second
delay before the control unit starts playing the home message.
Call Mode
This option enables or disables the speech dialler feature.
Messages
Use this option to record the speech messages you wish the speech dialler to use.
There are five messages slots available: The Home Message and Messages 1 to 4. The
control unit can record up to ten seconds of speech for the Home message, and up to five
seconds of speech for each of the alarm messages. Within each message, you can use
any of the following options:
Record Message
Press  to start recording. The control unit starts recording from its built-in
microphone. The display shows a progress bar indicating how long you have left to
record. Press  to end recording.
Play Message
Press  to play back the message.
Delete Message
Press  to delete the message. When the display asks “Delete Message?” press .
Triggers
For each Message 1-4, specify the event category that you want to associate with the
message. You can choose any one of the following:
Fire Alarm (see page 40)
Hold Up Alarm (see page 40)
Burglar Alarm (see page 40)
Technical Alarm (see page 41)
Tampers (see page 41)
Mains Fail (see A/C Fail, page 41)