Eaton Powerware 5125 - Page 28

INSTALLATION
EATON Powerware
®
5125 (9910-E65) UPS Installation Guide for IBM
®
Applications S 164201698 Rev 1
22
Table 8. Typical Power Connections (Figure 18–Figure 20) (continued)
DescriptionItem
7 PDU to UPS power cord
IBM FC Plug Type Supplier Description
6654 12 IBM Burndy to NEMA L6-30P, 4.3m/14 ft
2972 12 IBM Burndy to NEMA L6-30P, 4.3m/14 ft
2973 12 Eaton Burndy to NEMA L6-30P, 1.2m/4 ft
8 PDU to utility (mains) power cord*
IBM FC Plug Type Supplier Description
6654 12 IBM Burndy to NEMA L6-30P, 4.3m/14 ft
6655 40 IBM Burndy to RS 3750, 4.3m/14 ft
6656 46 IBM Burndy to IEC-309 (P+N+G) 32A, 4.3m/14 ft
6657 PDL IBM Burndy to PDL, 4.3m/14 ft
6658 KP IBM Burndy to KP, 4.3m/14 ft
9 2974 — Eaton Burndy to IEC 320-C20, 1.8m/6 ft
10 Output power (UPS to device) cords, located in the E65 accessory kit
Qty. Description
4 IEC 320-C13 to C14, 1.8m (6 ft)
1 IEC 320-C19 to C20, 2.7m (9 ft)
* Other power cords are supported by the PDU. Power cords shown are similar in voltage and amperage to the UPS.
NOTE E65 supports: PDU types 5160 or 9176 with FC 2970; PDU types 5161 or 9177 with
FC 2971.
NOTE E65 does not support iSeries PDU 5162, IEC-309 (3P+N+G) 16A.
NOTE E65 with 2972 or 2973 has a maximum output capacity of 4500 watts even though
IBM PDU 7188 or 9188 can support higher power output. Plan accordingly.