OPERATION
EATON Powerware
®
5125 (9910-E65) UPS Installation Guide for IBM
®
Applications S 164201698 Rev 1
31
If you press the On button and nothing happens, the UPS is still in
Operation mode. Repeat Step 1 to enter Configuration mode, and
then perform Step 2.
3. Press the Off
button ONCE to select the option.
Repeat Steps 2 and 3 for each option. Scrolling past the last
indicator returns to the first configuration option.
NOTE The UPS exits Configuration mode automatically after two minutes of inactivity.
4. Press the button to confirm the selection and exit Configuration
mode. If you do not press the
button, the UPS defaults to the
original settings.
3
2
4
On Button
Off Button
Alarm Reset Button
Configuration Mode Indicators
Press and hold the On and Alarm Reset
buttons simultaneously to enter
Configuration mode.
1
Press the On button to
scroll to the next option.
Press the Off button ONCE to
toggle an option on or off.
Press the Alarm Reset
buttontosavethesetting
and exit Configuration
mode.
Figure 24. Using Configuration Mode
To Next Page
Loading...
