General Description
Copyright © 2008 Eaton Corporation. All Rights Reserved.
IPN 997-00012-56C September 2008
7
External communications
Refer to the system controller handbook for information on these communications options.
Communications options SC200 SC100
Communication with DCTools via USB
-
Communication with DCTools or PowerManagerII via RS232
Communication with DCTools or PowerManagerII via
an external PSTN or GSM modem (dial-in and dial-out on alarm)
Communication with DCTools or PowerManagerII via Ethernet
-
Communication with any web browser software via an IP network
-
Communication with a Network Management System (NMS)
using SNMP
-
Alarm and status messages to GSM Short Messaging Service (SMS)
text capable cell phones
Communication with an alarm management system using
voltage-free relay contacts (on an IOBGP I/O board)
Compatible Software
The following software is compatible with the SC200 or SC100 system controller:
• DCTools Configuration Software. Latest version is available free from
www.powerware.com/downloads.
• PowerManagerII Remote Control and Monitoring Software. Contact your Eaton dc
product supplier for further information (see Worldwide Support on page
73).
Optional Battery Modules
Front View Rear View
"
19-inch rack mount battery module with 48V, 18Ah
battery
#
Socket for connection to next battery module
$
Connection cable to EPS2/EPS5 or previous
battery module
To Next Page
Loading...
