Installation
Copyright © 2008 Eaton Corporation. All Rights Reserved.
IPN 997-00012-56C September 2008
27
Step 2 - Route communications cable(s) to rear of SC200
"
Top cover
#
Cable entry (also used by temperature
sensor cable)
$
Communications cable
%
SC200 system controller
Step 3 - Plug into Ethernet and/or RS232 port as required
1 See the diagram on page
5 for position of Ethernet or RS232 port on rear
of SC200.
2 Secure the cable(s) to prevent strain on the connector.
Step 4 - Replace top cover
Procedure complete
To Next Page
Loading...
