echosens FibroScan 502 touch - CAP Result Zone (Option); Deleting Measurements

[SETE FIBROSCAN 502 TOUCH USER MANUAL FibroScan
6.6.8. CAP result zone (option)
Note: The CAP value is displayed only if the option is installed.
Ea The CAP is displayed with the M* and XL* probes only.
Median
The CAP (Controlled Attenuation Parameter) is expressed in decibels per meter (dB/m). This
value is the median of all valid measurements performed during the examination.
The CAP is calculated when the stiffness measurement is valid.
& Refer to the warning in Chapter 2 concerning interpretation of the result.
Interquartile range (IQR)
The interquartile range (IQR) is expressed in decibels per meter (dB/m). It represents
the interval around the median within which will fall 50% of all valid measurements. It is
recalculated after each new valid measurement.
6.6.9. Deleting measurements
Some or all of the measurements in the current examination may be canceled at any time
during the examination. The patient's data, displayed in the left-hand part of the window, are
saved.
38 03/2017 - ECHOSENSTM AND FIBROSCAN® ARE TRADEMARKS © COPYRIGHT ECHOSENS - ALL RIGHTS RESERVED E300M017.4