echosens FibroScan 502 touch - Cleaning the Probe (Housing, Cable and Transducer)

FibroScan
FIBROSCAN 502 TOUCH USER MANUAL FRETE]
8.1.2. Cleaning the probe (housing, cable and transducer)
E It is not necessary to switch off the device before cleaning the probe.
Surfaces must be cleaned in strict compliance with the following procedures:
1. Gently remove the gel using a soft cloth or wipe.
Cleaning the probe: A: Wipe.
5 Remove all traces of bodily fluid by cleaning the surfaces using a soft cloth or wipe
soaked in the recommended cleaning product.
3. If necessary, rinse the cleaned surfaces using a soft cloth soaked in water.
Dry, if necessary, using a dry cloth.
5. Wipe the surfaces using a soft cloth or wipe soaked in the recommended
decontamination solution.
Dry, if necessary, using a soft dry cloth.
7. Examine the transducer and probe cable for any damage such as cracks, breakage, or
liquid leakage.
If any damage is observed, stop using the probe and contact Echosens or its local
representative: service@echosens.com
Precautions
Do not submerge or soak the probe.
Apply the cleaning product and decontamination solution to the soft cloth, not directly on the
surface to be cleaned.
The probe must be cleaned after every use or between patients. Prior cleaning is necessary
in order to ensure effective decontamination.
Do not use a surgical brush to clean the probe. Even the use of flexible brushes could
damage the probe.
Take care not to introduce any cleaning product or decontamination solution into the probe
connector.
8.1.3. Recommended cleaning products
Echosens recommends use of the following products :
m Pure water, soapy water.
E300M017.4
03/2017 - ECHOSENSTM AND FIBROSCAN® ARE TRADEMARKS © COPYRIGHT ECHOSENS - ALL RIGHTS RESERVED 49