echosens FibroScan 502 touch - Regulations; Electromagnetic Emissions

FibroScan FIBROSCAN 502 TOUCH USER MANUAL EUS}
12. REGULATIONS
Electromagnetic interference (EMI) is a signal or emission, conveyed through open space
or through electrical or signal conductors, which may severely disrupt radio navigation or
other safety services, or seriously and frequently damage, obstruct or interrupt an authorized
radio communication service. These communication services include, but are not limited to,
commercial AM/FM radio services, television, cellular telephone services, radio detection,
air traffic control, radio paging and GSM systems. These authorized services, along with
unintentional sources of disturbance, such as digital equipment, including computer systems,
contribute to the electromagnetic environment.
Electromagnetic compatibility is the ability of the elements of an electronic device to interact
correctly with the electronic environment. Although this computer system has been designed
to conform to the restrictions of the EMI regulatory body, there is no guarantee concerning
interference that may occur in a specific installation. Should the device generate interference
with radio communication services (this may be determined by turning the device off and on),
users are encouraged to attempt to correct this phenomenon by adopting one or all of the
following measures:
m Change the orientation of the reception aerial.
и Reposition the computer relative to the receiver.
m Move the computer away from the receiver.
= Connect the computer to a different power socket such that the computer and receiver
are on different branch circuits.
12.1. ELECTROMAGNETIC EMISSIONS
The FibroScan 502 TOUCH is designed for use in the electromagnetic environment defined
below. The customer or the user of the FibroScan 502 TOUCH must ensure that it is used in
this type of environment.
Emissions testing Compliance Electromagnetic Environment - Directives |
CISPR RF Group 1 The FibroScan 502 TOUCH uses RF energy for its
emissions 11 internal functions only. Consequently, its RF emissions
are very low and unlikely to cause any interference with
nearby electronic equipment. |
CISPR RF Class A The FibroScan 502 TOUCH may be used on all premises |
emissions 11 other than domestic premises and those directly
~ connected to the public low voltage energy grid used to
Harmonic Class A supply domestic buildings.
emissions
IEC 61000-3-2
Voltage Compliant
fluctuations/flicker
IEC 61000-3-3
E300M017.4 03/2017 - ECHOSENSTM AND FIBROSCAN® ARE TRADEMARKS © COPYRIGHT ECHOSENS - ALL RIGHTS RESERVED 65