echosens FibroScan 502 touch - Integrate the Measurement Conditions

Fibroscan μμ —°}]
FIBROSCAN 502 TOUCH USER MANUAL [STEVE]
>| Press the last measurement to be deleted and then
the following button:
A confirmation request is displayed and indicates
the number of measurements remaining if deletion
is confirmed.
A Refer to the warning in Chapter 2 concerning deletion of measurements.
6.6.10. Adding a comment
You can add comments to the current examination :
m Press the ‘Comments’ field,
= Enter comments using the touchpanel.
Information entered in the ‘Comments’ field will appear on the examination result printout.
l The ‘Comments’ field cannot be added to or modified during an examination
review.
6.6.11. Integrate the measurement conditions
If the option is enabled in Configuration, the conditions under which the examination was
conducted can be filled in immediately after finishing the examination. The following input
fields are available:
E300M017.4
03/2017 - ECHOSENSTM AND FIBROSCAN® ARE TRADEMARKS © COPYRIGHT ECHOSENS - ALL RIGHTS RESERVED 39