echosens FibroScan 502 touch - Using the Device; Deleting Measurements; Switching off the Device; Cleaning and Maintenance

FibroScan
FIBROSCAN 502 TOUCH USER MANUAL TRUE]
concerning electromagnetic compatibility (EMC). It must be installed and set up
according to the EMC information given in this manual.
A The FibroScan 502 TOUCH device requires special precautions to be taken
2.4. USING THE DEVICE
个 Do not push or lean on the top of the FibroScan device.
To avoid tipping the FibroScan when moving it, move it slowly sideways and steer
it firmly by holding the decorative rods on the front and back of the device.
To avoid tipping the FibroScan when lowering it down a step, the operator must go
in front of the device and guide it on the way down.
2.5. DELETING MEASUREMENTS
All measurements taken before the one chosen for deletion will be eliminated from
the examination after confirmation.
2.6. SWITCHING OFF THE DEVICE
Never switch the device off during an examination or whilst in configuration mode.
A Never disconnect the main power supply when the device is switched on. Failure
to comply with these instructions may cause a malfunction of the device and/or
loss of data.
2.7. CLEANING AND MAINTENANCE
These maintenance operations must not be performed by a third party other than
a technician authorized by Echosens.
The opening or modification of the device by any person other than an authorized
Echosens technician is strictly prohibited.
No CD ROMs or DVD ROMs other than those provided by Echosens should be
inserted into the drive.
The probe must be calibrated periodically. Beyond this period, the manufacturer
no longer guarantees the performance characteristics of the probe.
2.8. CLEANING
To prevent electric shock, switch off the device and disconnect it from the power
supply before cleaning.
E300M017.4 03/2017 - ECHOSENSTM AND FIBROSCAN® ARE TRADEMARKS © COPYRIGHT ECHOSENS - ALL RIGHTS RESERVED
o