echosens FibroScan 502 touch - Page 60

EE FIBROSCAN 502 TOUCH USER MANUAL FibroScan
60
5x20
T 2A H250V
03/2017 - ECHOSENSTM AND FIBROSCAN® ARE TRADEMARKS © COPYRIGHT ECHOSENS - ALL RIGHTS RESERVED E300M017.4
Scrapping the button cell battery
The FibroScan uses a ‘button cell battery. This is a long-life battery
and it may never need replacing.
In the event of replacement, however, do not discard the old battery
With ordinary household waste. Contact your local waste processing
department for the address of the nearest battery disposal location.
Scrapping the FibroScan and its probe(s)
To reduce the risk of pollution by electrical and electronic waste,
and within the framework of European Directive 2011/65/EC, the
FibroScan device and its probe(s) must not be discarded with ordinary
household waste. Contact the local electrical and electronic waste
processing service for instructions.
Equipotential terminal
Protective ground
Alternating current
2-A accessible time-delay fuses
Applied part type B
Standby pushbutton
Main switch