Section 3
Installation
Page 3 - 4 EchoStar International Corporation
© 2001 EchoStar International Corporation
All rights reserved
FOR FIXED AND DISEQC 1..4 SWITCH INSTALLATIONS
FOR MOVEABLE DISH INSTALLATIONS (DISEQC1.2)
21. Make the required selections.
22. Read the available help text for information.
Note that only the white fields are selectable,
other fields show reference information.
23. Go to the Check Signal field.
24. On the RCU, press the OK key to advance.
25. Wait for the Checking Configuration to complete.
26. Make the required selections.
27. Read the available help text for information.
28. If the red dot in the transponder field stays:
a. select another transponder;
b. go to the check signal field;
c. on the RCU, press the OK key.
29. Go to the Search Channels field.
30. On the RCU, press the OK key to advance.
31. Wait for the search to complete:
a. the search completed popup menu appears.
32. On the RCU, press the OK key to end the initial
setup procedure.
21. Make the required selections.
22. Read the available help text for information.
Note that only the white fields are selectable,
other fields show reference information.
23. Go to the Program Satellites field.
24. On the RCU, press the OK key to advance.
To Next Page
Loading...
