EchoStar DSB-2200 2Ci Viaccess - Page 9

Installation Section 3
EcoNAV User Interface Page 3 - 3
© 2001 EchoStar International Corporation
All rights reserved
3
7. Make the required selections.
8. Read the available help text for information.
Note that only the white fields are selectable,
other fields show reference information.
9. Go to the Continue field.
10. On the RCU, press the OK key to advance.
11. Make the required selections.
12. Read the available help text for information.
13. Go to the Continue field.
14. On the RCU, press the OK key to advance.
NOTE
The receiver needs the correct local time to collect and show the EPG (Electronic
Program Guide). An incorrectly entered local time will result in no EPG information.
15. Make the required selections.
16. Read the available help text for information.
17. Go to the Press OK to set the time.
Note that the local time is shown correctly.
18. On the RCU, press the OK key to set the time.
19. Go to the Continue field.
20. On the RCU, press the OK key to advance.
NOTE
From the next step onwards, the procedure is divided in different configurations.
The configurations are; Fixed, DiSEqC1.2 and SMATV.
■ Fixed means set up a single dish or multiple dishes with DiSEqC1..4 switch;
■ DiSEqC 1.2 means set up a moveable dish according the DiSEqC 1.2 spec;
■ SMATV means set up for television distribution (cable network in buildings).