32
Basic operation
Here, the LPF (low-pass filter) to the non-fader pre-out can be
switched ON and OFF.
Since the low-pass filter passes only lower ranges (higher
ranges are cut off), efficient playback is enabled by cutting off
mid to higher range elements not needed for a woofer.
Turn [SEL] button to select X-OVER NF.
Press the [SEL] button.
The cross over (non-fader) switching mode is activated.
Turn [SEL] button to select ON or OFF.
Press the [RTN] button.
At this time, other adjustments can also be made in Sound
Adjustment Mode.
Press the [SOUND] button to exit Sound Adjustment
Mode.
Sound integration can be improved for full range speakers and
woofers by switching the phase.
Switch the phase and select an integration method that is
compatible.
Turn [SEL] button to select Non-FADER.
Press the [SEL] button.
The non-fader setting mode is activated.
Turn [SEL] button to select NORMAL or REVERSE.
Press the [RTN] button.
At this time, other adjustments can also be made in Sound
Adjustment Mode.
Press the [SOUND] button to exit Sound Adjustment
Mode.
To Next Page
Loading...
Need help?
General
