Eclipse CD5444 - Switching Audio Control Modes; VOL (VOLUME) Mode; BASS Mode

43
Basic operation
Various audio control modes may be fine-tuned using this
procedure.
Modes will switch in the order shown below each time the
button is pressed.
Switching audio control modes
Press the [AUDIO CONTROL] button for less than one
second to select the item to be adjusted.
1
Adjusts volume.
Turn the [AUDIO CONTROL] button to the left or right.
Turn to the right: Increases the volume.
Turn to the left: Decreases the volume.
VOL (VOLUME) Mode
Adjusts bass level. Bass mode can be adjusted for each
source (CDP/CDC, Memory Stick, FM and AM).
Turn the [AUDIO CONTROL] button to the left or right.
Turn to the right: Emphasizes low sounds.
Turn to the left: Softens low sounds.
BASS Mode
VOL TREBBASS
*
1
*
1
*
2
BAL
FAD
NON-FSVC
*
4
*
2
*
3
*1: When the sound adjustment mode is in normal mode, this
adjustment is not available. (Refer to page 96.)
*2: If the position selector is "ON", this adjustment is not available.
(Refer to page 98 and 107.)
*3: NON-FADER output does not reflect BASS, TREBLE, LOUDNESS
and EQUALIZER settings.
*4: Setting cannot be made in FM mode.
[AUDIO CONTROL] button