ecom-EN3
Page 55
Hint
The number and order of the measured values on the printout can be defined as
desired.
To adjust the number and order of the measured values on the
printout, proceed as follows:
1. Use the <F1> key to activate the value selection
2. Navigate to the corresponding line <up / down>
3. Select the measured value by pressing the <Enter> key
The following measurement and calculation values can be selected for the lines of the
printout:
1 T.Air 26 CO mg/N 51 SO2 mg/kWh
2 T.Gas 27 CO mg/kWh 52 SO2 mg/MJ
3 T.Boiler 28 CO mg/MJ 53 H2
4 T.Sensor 29 NO ppm 54 H2S
5 O2 30 NO ppm/N 55 Gas speed
6 CO 31 NO mg 56 Mass flow
7 NO 32 NO mg /N 57 CO x% Italy
8 NO2 33 NO mg/kWh 58 Eff._Hs
9 NOx 34 NO mg/MJ 59 Difference Temperature
10 SO2 35 NO2 ppm 60 Not used
11 CxHy 36 NO2 ppm/N 61 H2 ppm
12 CO2 37 NO2 mg 62 H2 ppm/N
13 Efficiency 38 NO2 mg/N 63 H2 mg
14 Losses 39 NO2 mg/kWh 64 H2 mg/N
15 Excess Air 40 NO2 mg/MJ 65 H2S ppm
16 Dew point 41 NOx ppm 66 H2S ppm/N
17 Poison Index 42 NOx ppm/N 67 H2S mg
18 Draught 43 NOx mg 68 H2S mg/N
19 Soot 44 NOx mg/N 69 Air pressure
20 Oil trace 45 NOx mg/kWh 70 Not used
21 Blank Line 46 NOx mg/MJ 71 CO Unit 2
22 Line 47 SO2 ppm 72 NO Unit2
23 CO ppm 48 SO2 ppm/N 73 NO2 Unit 2
24 CO ppm/N 49 SO2 mg 74 NOx Unit 2
25 CO mg 50 SO2 mg/N 75 SO2 Unit 2
To Next Page
Loading...
Need help?
General
