The data, information and descriptions, and the technology described herein are the exclusive intellectual property of Snap-on Climate Solutions S.r.l. and
constitute industrial secrets. Said information is communicated in strict confidentiality; said information may be used only for the purpose for which it is
communicated; said information may not be divulged, communicated, or revealed to third parties and/or reproduced by any means for any reason whatsoever; said
information is protected under applicable Italian competition and industrial property law.
Service manual Cinquecento12 (VA21) [MANUY2V.SB0] ed.1 ver.0.1.doc pag.54 - 09/11/2021
The following screen is displayed:
The oil must be added through the hole in which the oil cap was lodged by using a proper
funnel (ref 5, Fig.21).
Add oil a little at a time, waiting for the level to rise before each successive addition, until the oil
level is about ½ cm above the red mark on the indicator (ref 3, Fig.21).
Replace the filling cap (ref 1, Fig.21) and tighten down.
FIG. 21
TOOLS:
Funn
el
Disp
osal
conta
iner
Allen
wren
ch n°
5; 8.
Refill vacuum pump with new oil
To the center of the control glass
Then replace filling cap.
When done press ENTER to exit.
To Next Page
Loading...
