5.5.1 Install batteries
1. Remove the battery door on the back of the transmitter(s) by sliding
down the battery door, as shown in Figure 12 .
Figure 12: Battery installation for Multi-channel sensor
2. BEFORE inserting the batteries, locate the dip switches on the
inside cover of the lid of the transmitter.
3. Channel Number: The device supports up to eight sensors. To set
each channel number change Dip Switches 1, 2 and 3, as referenced
in Figure 13 .
4. Temperature Units of Measure: To change the transmitter display
units of measure (°F vs. °C), change Dip Switch 4, as referenced in
Figure 13.
Switch in down position. Switch in up position.
To Next Page
Loading...
