EDAN SE-1 - Page 20

SE-1 Electrocardiograph User Manual Introduction
- 13 -
6) LEAD (Lead Switch Key)
In the manual mode, press this key to switch the leads in order.
7) PRINT/STOP Key
Press this key to begin or stop printing ECG reports.
8) ON/OFF Key
After you connect the power cord to the outlet and press the mains switch, press this key
to turn on or off the device.
9) MENU Key
Press this key to open the system setup interface.
10) ID Setting Key
Press these two keys to set the patient ID. Press the up arrow key to increase the ID
number and press the down arrow key to decrease the ID number.
11) M/F
Press the M/F key to set the sex of the patient to Male or Female.