EDAN SE-300 Series - 4.2 Loading and Replacing Recorder Paper

SE-3&SE-300 Series Electrocardiograph User Manual Operation Preparations
- 22 -
♦ Built-in rechargeable battery
When the built-in rechargeable lithium battery is used, turn on the unit by pressing the
ON/OFF key on the control panel directly. Then the battery indicator lamp ( ) will be
lit and the battery symbol will be displayed on the LCD screen. Because of the
consumption during the storage and transport course, the battery capacity may not be
full. If the symbol and the Hint information BAT WEAK are displayed, which
means the battery capacity is low, please recharge the battery first.
Please refer to the maintenance section for how to recharge the battery. When the
battery is being recharged, SE-3/SE-300 series can be powered by the mains supply at
the same time.
WARNING
The potential equalization conductor of the unit should be connected to the potential
equalization bus bar of the electrical installation when necessary.
4.2 Loading/Replacing Recorder Paper
There are two kinds of recorder paper. One is the rolled thermal paper with the width of 80mm,
and the other is the folded thermal paper with the width of 80mm.
NOTE: When the folded thermal paper is used, the paper roller is unnecessary and must
be taken out.
When the recorder paper runs out or is not loaded, warning message Paper? will appear on the
screen. Then you should load or replace the recorder paper immediately.