EDAN SE-300 Series - Transmitting ECG Records through the Net Port (Optional, Only for Net Type)

SE-3&SE-300 Series Electrocardiograph User Manual Managing ECG Records
- 40 -
 Auto Transmission:
1 Press the MENU key to open the System Setup Screen.
2 Select the Transmission button, and then press the MENU key to enter the sub-window.
3 Set Auto Transmission to On and set Transmission mode to UART. Then press the
MENU key again to return to the Main Screen.
4 In the AUTO, RHYT, OFF-AUTO or OFF-RHTY mode, ECG data can be transmitted
through the UART port automatically after an ECG report is printed out.
 Manual Transmission:
1 Press the MENU key to open the System Setup Screen.
2 Select the Transmission button, and then press the MENU key to enter the sub-window.
3 Set Auto Transmission to Off and set Transmission mode to UART. Then press the
MENU key again to return to the Main Screen.
4 Press the RECALL key to open the File Manager screen (a).
1) Select the TransAll button, and then press the MENU key to confirm the operation.
NOTE: Please make sure the settings of Auto Transmission and Transmission
Mode in Transmission is correct.
2) If you want to transmit only one record, choose the patient record in the table, press the
MENU key to enter the File Manager screen (b). Select the Trans button and then press
the MENU key to confirm the operation.
NOTE: The transmission process is long, and please be patient to wait.
3) Press the RECALL key to return to the Main Screen.
7.1.2 Transmitting ECG Records through the Net Port (Optional,
Only for Net Type)
Connect the PC to the electrocardiograph with an Ethernet cable recommended by the
manufacturer. If the wireless AP transmission is used, connect the PC to one wireless AP, and
connect the electrocardiograph to the other wireless AP.
NOTE:
1) Only the wireless AP recommended by the manufacturer can be used.
2) For details on configuring the wireless AP, please refer to the user manual
delivered with the wireless AP.