EDAN SE-300 Series - 8.6 File Setup Options

SE-3&SE-300 Series Electrocardiograph User Manual Settings
- 55 -
Transmission Mode
Choose from: Ethernet or UART, the default value is Ethernet
Select Ethernet, ECG data will be transmitted to the PC through the
net port.
Select UART, ECG data will be transmitted to the PC through the
serial port.
FTP Information
Enter data in the FTP Path, FTP User Name textboxes.
IP Addresses
Set Server IP, Local IP, Set Gateway, Set Subnet Mask
For details, please refer to Section 7.1.1 "Transmitting ECG Data in
DAT Format".
NOTE: If WIFI is enabled and Auto Get IP is selected in the
WIFI Setup window, IP addresses can be acquired
automatically.
8.6 File Setup
Item
Description
Auto Save
Choose from: Off, To ECG or To U Disk, the default value is To ECG
Select Off, ECG data will not be saved.
Select To ECG, ECG data in the auto or rhythm mode will be saved in the
ECG automatically.
Select To U Disk, ECG data in the auto or rhythm mode will be
automatically saved to the directory of
ECGDATA\ECG-X\Store\Examination Date of the U disk after an ECG
report is printed out.