Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 764 –
show mvr6 members This command shows information about the current number of entries in the
forwarding database, or detailed information about a specific multicast address.
Syntax
show mvr6 [domain domain-id] members [ip-address]
domain-id - An independent multicast domain. (Range: 1-5)
ip-address - IPv6 address for an MVR6 multicast group.
Default Setting
Displays configuration settings for all domains and all forwarding entries.
Command Mode
Privileged Exec
Example
The following shows information about the number of multicast forwarding entries
currently active in domain 1:
Console#show mvr6 domain 1 members
MVR6 Domain : 1
MVR6 Forwarding Entry Count :1
Flag: S - Source port, R - Receiver port.
H - Host counts (number of hosts join the group on this port).
P - Port counts (number of forwarding ports).
Up time: Group elapsed time (d:h:m:s).
Expire : Group remaining time (m:s).
Group Address VLAN Port Up time Expire Count
------------------------------ ---- ----------- ----------- ------ --------
ff05::101 2 00:00:00:19 2(P)
2 Eth1/ 2(S)
1 Eth1/ 4(R) 0(H)
Console#
Table 147: show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR6.
Type Shows the MVR6 port type.
Status Shows the MVR6 status and interface status. MVR6 status for source ports is
“ACTIVE” if MVR6 is globally enabled on the switch. MVR6 status for receiver
ports is “ACTIVE” only if there are subscribers receiving multicast traffic from
one of the MVR6 groups, or a multicast group has been statically assigned to
an interface.
Immediate Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR6 group assigned to an interface, and the receiver
VLAN.
To Next Page
Loading...
Need help?
General